![]() ![]() Once connected, type the following commands: ![]() Connect to that COM port through Hyperterminal, found in the Accessories area of the Start Menu. Under the Ports section, find the COM port that's connected to the USB modem (ignore the Diagnostics mode). Once done, close the Rogers app that starts up, then head into the Device Manager ( Control Panel > System > Hardware > Device Manager). Using a Windows machine, plug in the USB device and go through the short install wizard. $ lsusb | grep -i zte Bus 001 Device 005: ID 19d2: 0124 ZTE WCDMA Technologies MSM A few seconds later, it will turn on again and it will be identified as modem by the kernel: The easiest way to switch to modem mode is by ejecting the CD-ROM:Īfter that, the led will turn off. $ lsusb | grep -i zte Bus 001 Device 005: ID 19d2: 0150 ZTE WCDMA Technologies MSM scsi 24:0:0:0: CD-ROM ZTE USB SCSI CD-ROM 2.31 PQ: 0 ANSI: 0 # dmesg | tail usb 1-5: new high-speed USB device number 4 using ehci_hcd You can find out the name of the device by using dmesg: When you first plug the device, it is identified as a USB SCSI CD-ROM. 1.3 Disable CD mode on the device with wvdialĬonfiguration Switch from CD mode to modem mode on the device.1.1 Switch from CD mode to modem mode on the device. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |